TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 576 of 933

TM 9-2520-270-34

75. INSTALL TWO NEW BEARINGS (1) ON

GEARSHAFT (2).

a. If either bearing (1) was removed, go to

step 75b. If not, go to step 76.

b. Using arbor press and bearing installer

(Item 7), press either bearing(s) (1) onto

gearshaft (2).

76. INSTALL RETAINING RING (3), IF

REMOVED.

a. Using retaining-ring pliers (Item 59),

install retaining ring (3) on gearshatt (2).

77. REPAIRER AND HELPER, PLACE

HOUSING (4) ON TWO WOOD BLOCKS.

78. INSTALL GEARSHAFT (2).

a. Using plastic-faced hammer, tap

gearshaft (2) into housing (4).

79.

INSTALL BEARING INNER RACE (5) IF

REMOVED.

a.

b.

Place bearing inner race (5) on gear

hub (6) with thick wall portion of race

facing gear (7).

Use bearing installer (Item 14A), press

bearing inner race (5) onto gear hub (6).

GO TO NEXT PAGE

Change 4

4-251