TM-9-2520-270-34
HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY
TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE
NOVEMBER 1984
TM-9-2520-270-34 - Page 566 of 933
TM 9-2520-270-34
21. REPAIRER AND HELPER TURN
HOUSING (1) OVER.
22. REMOVE SPUR GEARSHAFT (2).
a. Using pry bar, pry out gearshaft (2).
NOTE
Ball bearings might not come out with spur
gearshaft. One bearing may stay in intermediate
housing, the other bearing may stay in
single disk brake.
25. INSPECT TWO BALL BEARINGS (4).
a. Inspect bearings (4) on each
end of gearshaft (2) for damage.
See TM 9-214.
b. If either bearing (4) is damaged, go
to step 26. If not, go to step 28.
23. INSPECT RETAINING RING (3).
a. Inspect retaining ring (3) for damage.
See page 2-5.
b. If retaining ring (3) is damaged, go to
step 24. If not, go to step 25.
24. USING RETAINING-RING PLIERS
(ITEM 59), REMOVE AND DISCARD
RETAINING RING (3).
26. REMOVE DAMAGED BEARING(S) (4).
a. Using mechanical puller kit, remove
damaged bearing(s) (4). Discard
bearings.
GO TO NEXT PAGE
Change 3
4-241
Back to Top
