TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 560 of 933

TM 9-2520-270-34

3. INSPECT GEAR (1) AND BALL

BEARING (2).

a. Inspect gear (1) for damage. See

page 2-6.

b. If gear (1) is not damaged, go to step 4.

c. If gear (1) is damaged, replace gear

and bearing (2) and go to step 6.4.

4. INSPECT BEARING (2).

a. Inspect bearing (2) for damage. See

TM 9-214.

b. If bearing (2) is damaged, go to step 5.

c. If bearing (2) is not damaged, go to

step 6.4.

WARNING

Retaining ring is installed

under high tension. Use care

when removing and installing

retaining ring. Personnel can

be injured. Always wear

goggles.

5. REMOVE BEARING (2).

a. Using retaining ring pliers (Item 59),

remove retaining ring (3) from gear (1).

b. Remove end plate (4) and bearing (2).

Discard end plate and bearing.

6. REMOVE BEARING INNER RACE (5)

FROM SPUR GEAR (1).

a. Using two pry bars, slowly pry off

bearing inner race (5). Discard bearing

inner race.

Change 4

4-237