TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 569 of 933

TM 9-2520-270-34

36. CHECK GEAR (1).

a.

b.

Using telescoping gage set and

micrometer caliper set, measure

inside diameter (2).

Replace gear (1) if measurement is

greater than 5.9051 inches

(150.000 mm).

38. INSPECT LUBE BLOCK (3).

a. Inspect lube block bores (7)

and (8) for chips and dirt.

b. If bores (7) or (8) are plugged,

clean them. See page 2-2.

37. REMOVE OIL LUBE BLOCK (3) AND

GASKET (4).

a. Remove two screws (5) and

washers (6).

b. Remove lube block (3).

c. Remove and discard gasket (4).

39.

40.

a.

b.

REPAIRER AND HELPER

TURN HOUSING (9) OVER.

INSPECT FOUR BRAKE PADS (10).

Inspect four pads (10) for damage.

See page 2-5.

If pads (10) are not damaged, go to

step 41. If any pad is damaged, go

to step 42.

4-244