TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 461 of 620

TM 9-2520-272-40

0056

21.Put lifter (Figure 25, Item 32) over end of shouldered shaft (range input shaft) (Figure 25, Item 35) and put lower

end of lifter in groove below area of center sun gear (Figure 25, Item 54) that has splines.

22.Use thumb screw (Figure 25, Item 33) on lifter (Figure 25, Item 32) to tighten bottom of lifting tool (Figure

25, Item 32) in groove.

23.Install hook (Figure 25, Item 31) in top of lifter (Figure 25, Item 32).

24.Use hoist (Figure 25, Item 30), trestle, hook (Figure 25, Item 31), and lifter (Figure 25, Item 32) to lower range

input shaft (Figure 25, Item 35) and attached center carrier assembly (Figure 25, Item 27) against retaining

ring (Figure 25, Item 37).

25.Remove hook (Figure 25, Item 31) and lifter (Figure 25, Item 32).