TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 470 of 620

TM 9-2520-272-40

0056

54.Align clutch plates in fourth and reverse clutch assembly (Figure 35, Item 9). Install forward clutch housing

assembly (Figure 36, Item 6) into fourth and reverse clutch assembly (Figure 35, Item 9).

NOTE

If forward clutch does not easily install, position mating output gear on the hub to use as a tool

to help move the hub slightly back and forth, and left and right to install. The forward clutch

housing is fully installed when it moves evenly in all four directions.

55.Turn forward clutch housing assembly (Figure 36, Item 6) so that one of the slotted openings (Figure 36, Item 3)

is positioned over the bolt holes for pitot (Figure 36, Item 5).

56.Install pitot (Figure 36, Item 5). Install two screws (Figure 36, Item 4) to hold pitot (Figure 36, Item 5) in position.

57.Torque two screws (Figure 36, Item 4) to 108 to 132 lb-in. (12 to 15 N·m).

58.Put retaining f xture (Figure 36, Item 2) in position on forward clutch housing (Figure 36, Item 6) and center

housing (Figure 36, Item 1).

59.Install 3/8-16 x 3/4 inch bolt (Figure 36, Item 7) to hold retaining f xture (Figure 36, Item 2) in position

60.Turn transmission right end up.