TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012
TM-9-2520-272-40

  TM-9-2520-272-40 - Page 477 of 620

TM 9-2520-272-40
0058
CAUTION
When lowering bevel gear assembly onto work table, be careful not to bend or break tubes.
Bent or broken tubes may cause bevel gear assembly to malfunction and may not align with
clearances when bevel gear assembly is installed.
3. Lower bevel gear assembly (Figure 2, Item 5) carefully over work table. While lowering, turn assembly so that it
is supported by wooden block.
4. Remove multiple-leg sling from bevel gear assembly (Figure 2, Item 5).


Back to Top