TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 484 of 620

TM 9-2520-272-40

0059

15.Remove spring (Figure 4, Item 20) and valve (Figure 4, Item 21) that were exposed when output oil pump

assembly was removed.

16.Remove nine bolts (Figure 4, Item 24) and nine washers (Figure 4, Item 23). Remove check valve (push-start)

valve body (Figure 4, Item 22).

17.Remove bolt (Figure 5, Item 25) and washer (Figure 5, Item 26) that attach reverse signal tube (Figure 5,

Item 27) to bevel gear carrier assembly.

18.Remove clamp (Figure 5, Item 28) from reverse signal tube (Figure 5, Item 27).

NOTE

If bevel gear assembly must be sent to Depot Maintenance for overhaul, do Step 19. If not,

go to Step 20.

19.Install washer (Figure 5, Item 26) and bolt (Figure 5, Item 25). Torque bolt (Figure 5, Item 25) to 36 to

43 lb-ft (49 to 58 N·m).