TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 472 of 620

TM 9-2520-272-40

0057

REMOVE IDLER GEAR ASSEMBLY

NOTE

Transmission is on maintenance stand, left end up.

1. Remove six bolts (Figure 1, Item 1) and six washers (Figure 1, Item 2) that connect bearing retaining plate

(Figure 1, Item 3) to center housing (Figure 1, Item 4).

2. Install two 3/8-16 x 1 inch jack bolts (Figure 2, Item 5) in jack bolt holes (Figure 2, Item 6) in bearing retainer

plate (Figure 2, Item 3). Tighten two jack bolts (Figure 2, Item 5) evenly until bearing retainer plate loosens.

NOTE

Outer race of bearing, located on top of hydrostatic pump idler gear, will come off with bearing

retainer plate.

3. Remove retaining plate (Figure 2, Item 3).

4. Remove two jack bolts (Figure 2, Item 5).