TM-9-2520-272-40
CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A
TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL
FEBRUARY 2012
TM-9-2520-272-40 - Page 68 of 620
TM 9-2520-272-40
0007
REMOVE TOP COVER ASSEMBLY
CAUTION
Be careful not to let dirt get into control valve assemblies when top cover is removed.
Contamination of control valves can cause transmission failure.
NOTE
Make sure transmission is in an upright position on f oor or work table during maintenance.
1. Remove 15 machine bolts (Figure 1, Item 3), nine machine bolts (Figure 1, Item 2), and two machine bolts
(Figure 1, Item 1) from transmission top cover (Figure 1, Item 4).
2. Remove transmission top cover (Figure 1, Item 4) and transmission top cover gasket (Figure 1, Item 5)
from transmission. If necessary, tap cover (Figure 1, Item 4) with plastic-faced hammer to loosen. Discard
transmission top cover gasket.
Back to Top
