TM-9-2520-272-40
CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A
TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL
FEBRUARY 2012
TM-9-2520-272-40 - Page 72 of 620
TM 9-2520-272-40
0008
CAUTION
Be careful to avoid letting dirt get into the control valve assemblies when top cover assembly is
removed. Contamination of control valves can cause transmission failure.
NOTE
Control valve assemblies are removed from transmission with solenoids attached.
Wiring harness does not have to be removed to remove control valve assemblies, except for
wiring harness ground connector.
One bolt and washer are removed from control valve assembly when harness ground connector
is removed.
Make sure transmission is in upright position on f oor or work table.
No solenoid should be removed from control valve assemblies unless test procedures have
established that solenoid malfunction exists.
When necessary to replace a solenoid or to repair a solenoid connector, refer to Replace
Solenoids and Terminals, WP 0070.
0008
‐
2
Back to Top
