TM-9-2540-207-14-P
HEATER, VEHICULAR COMPARTMENT, MODEL: A20
TECHNICAL MANUAL; OPERATOR, FIELD, AND SUSTAINMENT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2007
TM-9-2540-207-14-P - Page 53 of 288
TM 9-2540-207-14&P
5-9
5.4.1 Top Cover
Figure 5.4-2 Top Cover
5.4.1.1 Removal
1.
Use either a 1/4" nut driver, a 1/4" socket, or #2 flat blade screwdriver to remove four (4)
#8-32 machine screws and star washers.
2.
Gently pull top cover away from Top Housing.
Note:
The Diagnostic Code Label is permanently attached with adhesive
to the Top Cover.
5.4.1.2 Installation
1.
Align the slot in the Top Cover with the 1/8 inch NPT inlet fitting in the Top Housing, and
place the Top Cover onto the Top Housing.
Ensure the two sides of the Top Cover are kept
inside
the edges of the Top Shell.
2.
Use either a 1/4" nut driver, a 1/4" socket, or a #2 flat blade screwdriver to secure the Top
Cover to the Top Housing with four (4) #8-32 machine screws and star washers.
Note: Ensure that the Wiring Harness is properly tucked inside the Top
Housing and the Top Cover does not put pressure on any components or
other wires.
Back to Top
