TM-9-2540-207-14-P
HEATER, VEHICULAR COMPARTMENT, MODEL: A20
TECHNICAL MANUAL; OPERATOR, FIELD, AND SUSTAINMENT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2007
TM-9-2540-207-14-P - Page 59 of 288
TM 9-2540-207-14&P
5-15
5.6.1
Vent Fan Assembly Repair
5.6.1.1 Vent Fan Assembly Repair Procedure For Design Iterations 1 and 2 Only. (Refer to
Section 5.6.1.2 for Design Iteration 3)
Figure 5.6-2 Vent Fan Assembly
5.6.1.1.1 Removal
During the following operations take care not to damage the electronic boards.
Note: It is NOT necessary to remove the Dual Air Adapter for this
operation.
1.
Remove Top Shell (ref. 5.4.2).
2.
Remove Bottom Shell (ref. 5.4.3).
3.
Disconnect
Wiring Harness
connection
J6
to the Vent Fan Driver Board.
Note: Connector J6 is released by pressing the sides of the connector
together with your fingers, releasing the locking tabs, and gently pulling
apart the two halves.
Back to Top
