TM-9-2540-207-14-P
HEATER, VEHICULAR COMPARTMENT, MODEL: A20
TECHNICAL MANUAL; OPERATOR, FIELD, AND SUSTAINMENT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2007
TM-9-2540-207-14-P - Page 57 of 288
TM 9-2540-207-14&P
5-13
Bottom Shell (Continued)
Installation (Continued)
1.
Replace Bottom Shell ensuring the holes in the Bottom Shell line up with the fasteners
on the Heat Exchanger.
Note: To allow alignment of Bottom Shell and screw holes, adjust the slider
plate found at the exhaust hole in the Bottom Shell.
Tip: Fit the Bottom Shell seams into the slots on each end of the heater
before tightening the screws.
2.
Using a 1/4" nut driver or 1/4" socket, install three (3) self tapping screws.
3.
Install Top Shell (ref. 5.4.2).
5.5
Ignitor & Ignitor Holder
Refer to Section 4.4.1.
Back to Top
