TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 416 of 779

1. Remove actuating clutch piston (A) from pressure

plate.

2. Carefully remove outer piston ring (B).

3. Remove inner piston ring (C).

Remove

1. Remove clutch pressure plate (A) with assembled

clutch piston from drive hub.

2. Remove three clutch springs (B) from hub.

3. Remove 15 clutch balls (C) from hub.

Install

1. Position 15 clutch balls (C) in drive hub.

2. Position three clutch springs (B) in hub.

3. Position clutch pressure plate (A) with assembled

clutch piston from hub.

Figure 6-142. Removing or installing clutch

pressure plate, clutch springs, and balls

(piston actuated clutch).

Figure 6-143. Removing actuating clutch

piston and piston rings (piston

actuated clutch).

6-122