TM-9-2815-202-34

ENGINE, DIESEL W/CONTAINER: MODEL 7083-7395, 7083-7396, 7083-7398 AND 7083-7399

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

FEBRUARY 1990

TM-9-2815-202-34 - Page 186 of 670

TM9-2815-202-34

4-24. FLYWHEEL

•

•

•

(5)

(6)

(7)

(8)

(9)

HOUSING REPLACEMENT (Cont)

NOTE

Install all flywheel housing attaching bolts finger tight.

Insure shim (37) is in position before installing bolt (4) and flat washer (5).

Effective after engine number 8VA-349268, bolt (4) and flat washer (5) is used with

flywheel housing.

Install bolt (4), flat washer (5), three bolts (6), and three flat washers (7) into bell area of

flywheel housing.

Remove four guide studs (10). Install six bolts (8) and six flat washers (9) into bell area of

flywheel housing.

Install seven bolts (11) and seven Iockwashers (12) to upper partof flywheel housing.

Install two bolts (13) and two Iockwashers (14) to front of flywheel housing (one on each

side).

Install gasket (22) and access cover (19) to left bank inspection hole in flywheel housing.

Secure in place with four bolts (17), four flat washers (18), four Iockwashers (16), four nuts

(15),t wo bolts (20), and two Iockwashers (21). Torque two bolts (20) to 30-35 Ib-ft

(41-47 N-m).

4-8 4

Change 1