TM-9-2815-202-34

ENGINE, DIESEL W/CONTAINER: MODEL 7083-7395, 7083-7396, 7083-7398 AND 7083-7399

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

FEBRUARY 1990

  TM-9-2815-202-34 - Page 217 of 670

TM9-2815-202-34
4-29. CAMSHAFT AND GEAR ASSEMBLIES REPLACEMENT (Cent)
NOTE
Oversize thrust washers are available in sizes of 0.005 and 0.010 inch to compensate
for excessive end thrust.
(16) Using feeler gage, measure end thrust between thrust washer (29) and thrust shoulder (44)
on each camshaft assembly. Required clearance is 0.003 to 0.015 inch with new parts and a
maximum of 0.018 inch with used parts. If necessary, install an oversize thrust washer for
required end thrust clearance.
.
FEELER
END OF TASK
FOLLOW-ON MAINTENANCE
e
Para Description
4-27 Install cylinder heads
4-24 Install flywheel housing
o
4-21 Install camshaft front cover
4-115


Back to Top