TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 576 of 596

TM 9-2815-205-34

APPENDIX G

ENGINE REPAIR SPECIFICATIONS

Section L INTRODUCTION

G-1 SCOPE

This appendix lists the repair specifications for the 6V53 Model 5063-5299, 5063-5392, 5063-5393,

5063-5395, 5063-5398, 5063-539F and 5063-539L engines.

G-2 EXPLANATION OF COLUMNS

a. Column 1 — Point of Measurement.

This column lists the area of the engine (e.g., “CYLINDER

BLOCK), then lists the specific component (e.g.,

“Main Bearing Bore”), and finally describes the critical

dimension (e.g., “Inside diameter”).

b. Column 2 — New Minimum.

This column lists the minimum acceptable dimension of the new part.

All dimensions are in inches unless stated differently.

c. Column 3 — New Maximum.

This column lists the maximum acceptable dimension of the new

part. All dimensions are in inches unless stated differently.

d. Column 4 — Wear Limit.

This column lists the maximum acceptable deviation for the used part. All

dimensions are in inches unless stated differently. An Asterisk (*) in this column indicates the part must

keep the same minimum and maximum limit as the new part.

Change 1

G-1