TM-9-2815-205-34
ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
AUGUST 1992
TM-9-2815-205-34 - Page 581 of 596
TM 9-2815-205-34
Section Il. ENGINE REPAIR SPECIFICATIONS (Cont)
(1)
POINT OF MEASUREMENT
(2)
NEW
MINIMUM
(inches)
(3)
NEW
MAXIMUM
(inches)
CAM FOLLOWERS
Diameter (follower body)
Diameter (roller pin hole)
Diameter (roller pin)
Outside diameter (roller)
Inside diameter (roller bushing)
Clearance (follower body to head)
Roller and Pins
Clearance (pin to bushing)
Side clearance (roller to follower)
Clearance (cam follower guide to cam follower legs)
1.0600
0.4362
0.4374
0.9077
0.4390
0.0016
0.0013
0.0150
0.0050
CAM FOLLOWER SPRINGS
Load at 2.1406 inches (length)
250. lb
BLOWER
Backlash (rotor gears)
0.0005
Backlash (between blower drive gear and camshaft gear) 0.0030
Oil seal depth (below end plate surface)
0.0020
Clearances
Thrust plate to thrust washers
0.0025
Rotor to air outlet side of housing
Rotor to air inlet side of housing
Rotor to front end plate (turbocharged)
Rotor to front end plate (nonturbocharged)
Rotor to rear end plate (turbocharged)
Rotor to rear end plate (nonturbocharged)
Rotor to rotor (turbocharged)
Rotor to rotor (nonturbocharged)
OIL PUMP
Lobe clearance (inner and outer rotors)
0.0005
Clearance (pump body to side of inner and outer rotor)
0.0010
FUEL INJECTOR
Follower spring load at 1.028 inches (length)
70. lb
1.0610
0.4372
0.4377
0.9082
0.4395
0.0036
0.0021
0.0230
0.0025
0.0070
0.0080
0.0050
0.0040
0.0100
0.0100
0.0080
0.0120
0.0100
0.0130
0.0090
0.0110
0.0035
(4)
WEAR
LIMIT
(inches)
0.0060
horiz 0.010
0.0230
0.0035
G-6
Back to Top
