TM-9-2815-205-34
ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
AUGUST 1992
TM-9-2815-205-34 - Page 577 of 596
TM 9-2815-205-34
Section Il. ENGINE REPAIR SPECIFICATIONS
(1)
POINT OF MEASUREMENT
CYLINDER BLOCK
Cylinder Sleeve Bore
Diameter (top)
Diameter (center)
Diameter (bottom)
Out-of-round
Taper
Cylinder liner counterbore
Diameter
Depth
Main bearing bore
Inside diameter (vertical axis)
Camshaft Bore (oversize bearing)
Intermediate
Top surface of block
Flatness (transverse)
Flatness (longitudinal)
Depth of Counterbores (top surface)
Cylinder head seal strip groove
Water holes (intermediate)
Water holes (end)
Oil holes
CYLINDER LINERS
Outside diameter (upper seal ring surface)
Outside diameter (lower seal ring surface)
Inside diameter
Out-of-round (inside diameter)
Taper (inside diameter)
Depth of flange below block
Variation in depth between adjacent liners
PISTON ASSEMBLY (TRUNK TYPE)
Piston
Diameter (at skirt-turbocharged)
Diameter (at skirt-nonturbocharged)
Clearance (skirt to liner-turbocharged)
Clearance (skirt to Iiner-nonturbocharged)
Out-of-round and taper
Inside diameter (pin bushing)
Compression Rings
Gap
4.5195
4.4865
4.3565
0.0015
4.8200
0.3000
3.7510
2.3850
2.3750
0.0970
0.1090
0.0920
0.0920
4.4850
4.3550
3.8752
0.0020
0.0010
0.0465
0.0020
3.8699
3.8679
0.0027
0.0047
1.3775
0.0200
4.5215
4.4880
4.3575
0.0020
0.0015
4.8350
0.3020
3.7520
2.3860
2.3760
0.0030
0.0060
0.1070
0.1150
0.0980
0.0980
4.4860
4.3560
3.8767
0.0030
0.0020
0.0500
0.0020
3.8721
3.8701
0.0068
0.0088
0.0005
1.3780
0.0460
4.5235
4,4900
4.3595
●
0.0020
●
●
●
☛
●
●
●
●
●
●
●
●
●
●
●
0.0500
●
●
●
0.0100
0.0120
●
●
0.0600
G-2
Back to Top
