TM-9-2815-205-34
ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
AUGUST 1992
TM-9-2815-205-34 - Page 580 of 596
(1)
POINT OF MEASUREMENT
(2)
NEW
MINIMUM
(inches)
(3)
NEW
MAXIMUM
(inches)
(4)
WEAR
LIMIT
(inches)
CRANKSHAFT TIMING GEAR
Backlash
Inside diameter
Outside diameter (crankshaft)
BLOWER DRIVE GEAR
Backlash
Thrust washer thickness
Endplay (blower drive gear shaft)
FUEL PUMP DRIVE GEAR
Backlash
Bearing (inside diameter)
Clearance (bearing to hub)
Endplay
Hub (outside diameter)
Thrust washer thickness
CYLINDER HEAD
Cam follower bore
Valve insert counterbore (diameter)
EXHAUST VALVE INSERTS
Outside diameter
Seat width
Valve seat runout
EXHAUST VALVES
Stem diameter
Valve head to cylinder head distance
EXHAUST VALVE SPRINGS
Load at 1.93 inches (length)
VALVE GUIDES
Distance below top of head
Inside diameter
Clearance (valve stem to guide)
ROCKER ARMS AND SHAFTS
Diameter (rocker shaft)
Diameter (injector rocker arm)
Diameter (valve rocker arm)
Clearance (shaft to injector rocker arm bushing)
Clearance (shaft to valve rocker arm bore)
0.0005
4.0575
4.0600
0.0030
0.0930
0.0040
0.0030
1.1220
0.0020
0.0050
1.1200
0.1580
1.0626
1.1590
1.1605
0.0468
0.0020
0.2480
.flush.
25. lb
0.1500
0.2505
0.0017
0.8735
0.8750
0.8753
0.0010
0.0013
0.0050
4.0585
4.0610
0.0050
0.1030
0.0120
0.0050
1.1230
0.0035
0.0180
1.1205
0.1600
1.0636
1.1600
1.1615
0.0781
0.0020
0.2488
0.0240
recess.
0.1800
0.2515
0.0035
0.8740
0.8760
0.8763
0.0025
0.0028
0.0070
0.0070
0.0070
0.0220
0.0781
0.0390
recess
0.0050
0.0040
0.0040
G 5
TM 9-2815-205-34
Back to Top
