TM-9-2815-210-34-2-1

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 1 OF 2

APRIL 1981

TM-9-2815-210-34-2-1 - Page 244 of 259

TM 9-2815-210-34-2-1

3-52. REMOVING CYLINDER BLOCK FROM OVERHAUL STAND.

FRAME 1

1.

Put two crossbars (1) on four studs (2) and screw on four nuts (3).

2.

Put lifting sling (4) with hoist hook (5) under two cross bars (1) as shown.

3.

Raise hoist until lifting sling (4) is holding weight of cylinder block (6).

4.

Working on side of overhaul stand (7) without crank handle, loosen three

capscrews

8).

5.

Take out three capscrews (9) and slide three universal mounting arms (10)

away from cylinder block (6).

GO TO FRAME 2

3-196