TM-9-2815-210-34-2-1
ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER
TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 1 OF 2
APRIL 1981
TM-9-2815-210-34-2-1 - Page 239 of 259
TM 9-2815-210-34-2-1
FRAME 7
CAUTION
1.
2.
3.
Take out
Take out
Be careful not to bend or scratch main bearing upper
halves (1 through 7) when taking them out.
NOTE
Main bearing upper halves are called by numbers one to
seven counting from front to rear of engine.
The number four main bearing upper half (1) is called
main thrust bearing upper half. It is different from
other main bearing upper halves (2 through 7) because
it has flanges (8).
main thrust bearing upper half (1).
number one main bearing upper half (2). Using tool tag and wire,
tag it with the number 1.
Do step 2 again for number two main bearing upper half (3), number three
main bearing upper half (4), number five main bearing upper half (5), number
six main bearing upper half (6), and number seven main bearing upper half
(7) .
END OF TASK
3-191
Back to Top
