TM-9-2815-210-34-2-1
ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER
TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 1 OF 2
APRIL 1981
TM-9-2815-210-34-2-1 - Page 34 of 259
TM 9-2815-210-34-2-1
2-3.
REMOVAL OF ENGINE FROM SHIPPING AND STORAGE CONTAINER.
NOTE
This task is the same for all engines.
Engine LDS-465-1A is shown.
FRAME 1
1.
Unscrew and take out pneumatic tank valve cap (1).
2.
If valve cap (1) has slot,
use slotted end of valve cap to unscrew and take
out valve core (2) to vent shipping and storage container (3). If valve cap
does not have slot, use valve stem repair tool to unscrew and take out valve
core to vent shipping and storage cent airier.
3.
Using slotted end of valve cap (1) or valve stem repair tool, screw valve
core (2) back into pneumatic tank valve (4) and tighten. Screw valve cap
back on finger tight.
GO TO FRAME 2
2-2
Back to Top
