TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 607 of 968

TM 9-2815-210-34-2-2

4-74. FLAME HEATER IGNITION UNIT (SIDE-MOUNTED SYSTEM).

For procedures

to repair the flame heater side-mounted ignition unit, refer to flame heater ignition

unit (covered system), para 4-65c.

4-75. FLAME HEATER WIRING HARNESS AND ELECTRICAL LEAD ASSEMBLY (SIDE-

MOUNTED SYSTEM).

For procedures to repair the side-mounted heater wiring

harness, refer to covered flame heater wiring harness, para 4-67b.

4-76. FLAME HEATER NOZZLE AND VALVE ASSEMBLY (SIDE-MOUNTED SYSTEM).

a .

Cleaning and Inspection.

FRAME 1

1.

2.

3.

4.

5.

Leave felt fuel line filters in fuel inlet (1) and outlet (2) openings in place.

Plug nozzle and valve assembly fuel inlet (1) and outlet (2) openings with

plugs.

WARNING

Dry cleaning solvent is flammable. Do not use

near an open flame.

Keep a fire extinguisher

nearby when solvent is used. Use only in well-

ventilated places.

Failure to do this may result

in injury to personnel and damage to equipment.

Clean nozzle and valve assembly (3) with dry cleaning solvent. Take off

heavy carbon deposits with a stiff brush.

pipe

Check that nozzle and valve assembly fuel inlet (1) and fuel outlet (2) threads

are not crossthreaded.

Check that nozzle and valve assembly (3) is not cracked or damaged. Get a

new nozzle and valve assembly if it is cracked or damaged.

END OF TASK

4-588