TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 905 of 968

TM 9-2815-210-34-2-2

f. Final Run-In.

FRAME 1

1.

Start and warm up engine. Refer to para 6-6b.

2.

Move throttle (1) until SPEED gage (2) shows 2800 rpm.

3.

Open engine load valve (3) until POWER gage (4) shows 160 to 205 HP.

4.

Set throttle (1) and load valve (3) to get 160 to 205 hp and

If hp reading is too high, open unload valve (5).

5.

Run engine at 160 to 200 hp and 2800 rpm for 1/2 hour.

6.

Write down fuel pressure shown on FUEL PRESS gage (6).

GO TO FRAME 2

2800 rpm.

6-50