TM-9-2815-220-34
ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED, 12-CYLINDER, ASSEMBLY; MODELS AVDS-1790-2C (2815-00-410-1203) AND AVDS-1790-2D (2815-00-410-1204)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
TM-9-2815-220-34 - Page 302 of 532
TM 9-2815±²²0³34
USE END OF tOOL
IDen´ifµED As
TOP
TApEReD RING gROoVe ga±²
piStON No. 1168394³´ ONLY
¶a·¸¸¸¹º
Fre
µ·¶¸¹º J»
ClEcki1±g pIston toP RinG G²Ove uS³g TapEr´d µIston RinG GaG¶.
I
c¼
Inspect compression R±ng
(»¼)
and
½¾¿À,
And oil
ContRoL Ring
(»ÁÂ
for scuff²ng, s³or´ngµ ³hippingµ
scRATches or ¶b·Asions. PAy pA¸¹´³uº¶R ¶ttention to
Those r´ngs which weRe FOund To Be sTicking in The
»iston r´ng grooves¼ I nstAº
Ã
The thRee loweR Rings in
theiR oRigin¶L position And check side CLe¶r¶nCe ¶s
des³Ribed in
ÄÅÆ
thRoUgh
ÇÈÉ
½eLow¾
ʾË
¿nsert RemoveR ¶nd Re»L¶³eR À¶Rt No¼
7ÌÍÎÅÏ7
in end g¶p ofÁing (Âig:
ÐÑÅÒÅÓ
¶nd ´nst¶LL oiL ³ontRoL
Ring in ÃoTTom pisTon Ä'´ng gRooVeÅ ÆnstAÇL two in-
teRmediAte compression R´ngS in The s¶me mAnneÈÅ
ÔÕÖ
MeAsure side cLe¶r¶nce oÉ the ThRee BotTom
Rings WÊTh ¶ thi³Kness g¶ge As shown ´n figuRe
×ØÅÒÈ.
M¶rË ALL Rings ÉOR RepL¶ÌeÍenT Îh¶t ARe ÏoÐ
w´Th´n Limits spEciÉied ´n repAiR stAnd¶Rds ÑtAbLe
×ÙÅÚÉÛ
ÒÓhe uppeR compression ring
ÜÝÞß
ÂigÔ
×àÅÒ×É
m¶Y ½e Õhe³ked BÖ meAsURing The d´¶meTeR oveR
RolL pins oR BY using the TApeRed »iston r´ng gRoove
improvised tooL× Øxcessive side ³LeAR¶n³e indicAtes
worn rings ¶nd/oR worn piston groovesÙ Úess thÛn
noRm¶L
!
Ü
L
e
¶RAnc
e
´Ýd´cAtÞs pro߶ßLe d¶à¶ge or
½ráAkAge ¶T the Ring LAndâ
áâã6
ãHänGe
ä
½¾02¿7ÀÁ
f·¸U¹E
ÂÃÄÅÆÇ ChÈÉkÊËÌÍ ÎÊsÏÐn ËÑÒÍ sÓdÈ ÔlÈÕrÕnÖÈ×
)
-
Back to Top
