TM-9-2815-224-34-P

ENGINE, DIESEL:8-CYLINDER TURBOCHARGED, DETROIT DIESEL CORPORATION MODEL 8V92TA

DIRECT SUPPORT AND GENERAL SUPPORT MAINTENACE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JANUARY 1988

TM-9-2815-224-34-P - Page 265 of 554

TM 9-2815-224-34&P

Blower and Water Pump Drives Maintenance Instructions (Cont)

10-4. BLOWER DRIVE SEAL RING REMOVAL/INSTALLATION.

This task covers:

a. Removal

c. Follow-on Maintenance

b. Installation

INITIAL SETUP

Models

All

Test Equipment

None

Special Tools

None

Supplies

Cement, general purpose, synthetic base,

Item 12, Appendix C

Personnel Required

MOS 63W, Wheel vehicle repairer

References

None

Equipment Condition

TM or Para

Condition Description

TM 9-2320-279-20 Engine cover removed.

Special Environmental Conditions

None

General Safety Instructions

None

Level of Maintenance

Direct Support

a. Removal.

(1) Loosen seal ring clamp (1) and slide clamp off blower drive

(2) Cut and remove blower drive seal ring (2).

b. Installation.

NOTE

Make sure cut ends of blower drive seal ring are straight and

clean.

(1) Cut blower drive seal ring (1) straight across.

WARNIN G

Use general purpose cement lightly and avoid contact with skin.

seal ring (2)

Cement will burn on contact.

(2) Apply general purpose cement to one end (2) of cut blower drive seal ring (1).

10-11