TM-9-2815-224-34-P

ENGINE, DIESEL:8-CYLINDER TURBOCHARGED, DETROIT DIESEL CORPORATION MODEL 8V92TA

DIRECT SUPPORT AND GENERAL SUPPORT MAINTENACE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JANUARY 1988

TM-9-2815-224-34-P - Page 260 of 554

NOTE

TM 9-2815-224-34&P

Blower and Water Pump Drives Maintenance Instructions (Cont)

10-2. BLOWER DRIVE SUPPORT REMOVAL/REPAIR/INSTALLATION (CONT).

e. Installation.

NOTE

Apply light coat of grease to both sides of

gasket.

(1)

(2)

(3)

(4)

(5)

Used

Install gasket (1) and blower drive

assembly (2) in flywheel housing (3).

Install two screws (4) and copper washers (5).

Tighten two screws (4) to 25 to 30 lb-ft (34 to

41-N”m).

Install crossover pipe (6), two

lockwashers (7), and screws (8).

Tighten clamp (9).

gear backlash cannot be over 0.010-in. (0.25 mm).

New gear backlash will measure 0.002-in. (0.05 mm) to

0.008-in. (0.20 mm). If backlash cannot be checked at face

of blower drive gear, check at accessory drive hub.

(6) Check backlash between blower drive gear (10) and

right bank camshaft gear (11).

f. Follow-on Maintenance.

Install blower (para 14-3).

END OF TASK

10-6