TM-9-2815-224-34-P

ENGINE, DIESEL:8-CYLINDER TURBOCHARGED, DETROIT DIESEL CORPORATION MODEL 8V92TA

DIRECT SUPPORT AND GENERAL SUPPORT MAINTENACE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JANUARY 1988

TM-9-2815-224-34-P - Page 278 of 554

TM 9-2815-224-34&P

Engine Brake Retarder Maintenance Instructions (Cont)

11-3.

ENGINE BRAKE RETARDER REPAIR (CONT).

(8)

Apply oil to seal (12) and install

in supply housing (3).

(9)

Apply lubricating oil to two

seals (13 and 14), and install on

solenoid valve (15).

NOTE

There are three models of solenoid valves.

Models A and B use a screw and

lockwasher to attach the solenoid wire,

while Model C has a spade (push-on) type

connector. If a Model A or B solenoid must

be replaced with a Model C solenoid, the

housing must be changed also. Refer to

TM 9-2320-279-24P for proper

identification of parts.

(10)

Install solenoid valve (15) in

supply housing (3).

(11)

Install setscrew (16) with nut (17)

in supply housing (3).

(12)

Apply lubricating oil to control valve (18) and

install control valve and two springs (19 and

20) in supply housing (3).

WARNING

Adhesives, solvents, and sealing compounds can burn

easily, can give off harmful vapors, and are harmful to

skin and clothing. To avoid injury or death, keep away

from open fire and use in well-ventilated area. If

adhesive, solvent, or sealing compound gets on skin or

clothing, wash immediately with soap and water.

(13)

Apply sealing and lubricating compound to

screw (21) and install cover (22) and screw in

supply housing (3).

(14)

Tighten screw (21) to 110 lb-in. (12 N•m).

d. Follow-on Maintenance.

None,

END OF TASK

11-10 Change 2