TM-9-2815-224-34-P

ENGINE, DIESEL:8-CYLINDER TURBOCHARGED, DETROIT DIESEL CORPORATION MODEL 8V92TA

DIRECT SUPPORT AND GENERAL SUPPORT MAINTENACE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JANUARY 1988

TM-9-2815-224-34-P - Page 349 of 554

Blower Maintenance Instructions (Cont)

(5)

(6)

(7)

(8)

(9)

(10)

Use five screws with puller tools on rear end plate. Use 5/16 in. -24 x 1-1/2 in.

(38 mm) screws and aline with tapped holes in gears.

Install puller tool on left timing gear (13) with two screws.

Install puller tool on right timing gear (14).

CAUTION

If puller screws are not tightened evenly during removal of timing gears damage

may result to gears.

Tighten screws (15) evenly to remove gears ( 13 and 14).

Remove pullers from gears (13 and 14)

Mark rear end plate to indicate top.

NOTE

Rig and mark shims and spacers.

Remove shims (16) and two spacers (17) from

each rotor shaft (18).

14-17