TM-9-2815-224-34-P

ENGINE, DIESEL:8-CYLINDER TURBOCHARGED, DETROIT DIESEL CORPORATION MODEL 8V92TA

DIRECT SUPPORT AND GENERAL SUPPORT MAINTENACE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JANUARY 1988

TM-9-2815-224-34-P - Page 357 of 554

(14)

Deleted.

CAUTION

Blower housing and rear end plate mating

surfaces must be perfectly flat and smooth or

parts will not seal.

Allow Teflon sealant to dry to the touch before

installing rear end plate. Teflon sealant must

not protrude into blower housing or damage to

blower may result.

Teflon sealant must not prevent rear end plate

from laying flat against the blower housing or

damage to blower may result.

(15)

(16)

(17)

(17.1)

Install two plastic seal protectors (4.3).

(17.2)

Install two pilot tools (4.6) on rotor shafts (4).

NOTE

TM 9-2815-224-34&P

Blower Maintenance Instructions (Cont)

Apply a thin, even coating of Teflon sealant over entire end surface of rear end plate side of

blower housing (7). Wipe off any excess sealant from housing bores.

Deleted.

Deleted.

Plastic seal protectors will be pushed out of seals when rear end plate is installed.

(18)

Position rear end plate (10) and aline dowel pins (11) to holes in blower housing (7).

(19)

Tap rear end plate (10) into blower housing (7).

(20)

Install and tighten two screws (12) to 10 lb-ft (14 N•m).

(21)

Apply lubricating oil to two ball

bearings (13).

(22)

Install two ball bearings (13) numbered

end up, in rear end plate (10) with

bearing installer.

Change 2

14-25