TM-9-2815-224-34-P

ENGINE, DIESEL:8-CYLINDER TURBOCHARGED, DETROIT DIESEL CORPORATION MODEL 8V92TA

DIRECT SUPPORT AND GENERAL SUPPORT MAINTENACE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JANUARY 1988

TM-9-2815-224-34-P - Page 423 of 554

TM 9-2815-224-34&P

Engine Governor Maintenance Instructions (Cont)

WARNIN G

Spring retainer holds down three

springs. Install retainer carefully.

Springs can eject parts with force

and cause injury.

Spring retainer is installed

approximately 1 in. (25 mm) in

governor housing.

(8) Install gasket (15) on governor

housing (16).

(9) Install spring retainer assembly (8)

through gasket (15) and governor

housing (16). Tighten locknut (7).

NOTE

Nut is installed 1/2 in. (12.7 mm) on

plunger.

(10)

(11)

(12)

(13)

(14)

Install nut (17) on plunger (10).

Install air cylinder assembly (18) on plunger (10).

Install idle adjusting screw (19) on air cylinder assembly (18) finger tight.

Loosen idle adjusting screw (19) one turn and install jamnut (20).

Install seal (21 ) on idle adjusting screw (19).

15-25