TM 9-2815-224-34&P
Engine Governor Maintenance Instructions (Cont)
c.
Assembly.
(1)
Install cylinder assembly (1) on air cylinder mounting plate (2) with two screws (3), washers (4)
lockwashers (5), and nuts (6).
(2)
Install extension stud (7) on shaft of cylinder assembly (1).
(3)
Position heat shield (8) on shaft of cylinder assembly (1).
(4)
Install spring pin (9), two screws (10), and nuts (11) in remote control lever (12). Do not tighten
nuts.
(5)
Place remote control lever (12) on extension stud (7).
d. Installation.
(1)
Install spacer (1) and speed control lever (2)
on speed control lever shaft (3).
(2)
Install throttle air cylinder (4) with three
screws (5), lockwashers (6), and two
washers (7).
Change 2
15-32.1