TM-9-2815-224-34-P

ENGINE, DIESEL:8-CYLINDER TURBOCHARGED, DETROIT DIESEL CORPORATION MODEL 8V92TA

DIRECT SUPPORT AND GENERAL SUPPORT MAINTENACE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JANUARY 1988

TM-9-2815-224-34-P - Page 427 of 554

(1)

(2)

TM 9-2815-224-34&P

Engine Governor Maintenance Instructions (Cont)

d. Assembly.

NOTE

Assembly pertains to Model A switch

only.

Silver end of wire is installed on

center screw on switch.

Install two screws (1), lockwashers (2),

diode wire (3), lockwasher (4), and two

terminals (5) on switch (6).

Install two screws (7), washers (8),

clamp (9), diode wire (10), switch (6),

bracket (11), and clamp (12) finger-tight.

NOTE

The switch should close when the gage is

inserted.

(3)

Adjust gap between bracket (11) and

switch (13). Gap between bracket and

switch must be 0.010 in. (0.254 mm).

(4)

Tighten two screws (7).

(5)

Install plunger (14) in plunger

assembly (15).

(6)

Install spring (16), washer (17), and

retaining ring (18).

(7)

Install nut (19), locknut (2O)

locking ring (21), and preformed

packing (22).

Change 2

15-29