TM-9-2815-224-34-P

ENGINE, DIESEL:8-CYLINDER TURBOCHARGED, DETROIT DIESEL CORPORATION MODEL 8V92TA

DIRECT SUPPORT AND GENERAL SUPPORT MAINTENACE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JANUARY 1988

TM-9-2815-224-34-P - Page 436 of 554

TM 9-2815-224-34&P

Engine Governor Maintenance Instructions (Cont)

15-10.

ENGINE STOP SOLENOID REMOVAL/INSTALLATION /ADJUSTMENT (CONT).

a. Removal.

NOTE

There are two models of engine stop solenoids. Model A works by electrical signal

only. Model B has a manual shutdown cable.

Some older model engines have one washer and do not have a bracket,

Screw that goes through bracket is longer than others.

(1)

(2)

Remove nut (1) and washer (2) from shaft (3).

Remove four nuts (4) lockwashers (5) three washers (6) spacer washer (6.1), and four srews (7)

from solenoid (8) and plate (9).

NOTE

Tag and mark wires before removal.

(3)

Remove screw (10), lockwasher (11), and ground wire (12).

15-36

Change 2