TM-9-2815-224-34-P

ENGINE, DIESEL:8-CYLINDER TURBOCHARGED, DETROIT DIESEL CORPORATION MODEL 8V92TA

DIRECT SUPPORT AND GENERAL SUPPORT MAINTENACE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JANUARY 1988

TM-9-2815-224-34-P - Page 441 of 554

TM

9-2815-224-34&P

Engine Governor Maintenance Instructions (Cont)

NOTE

Some older model engines have one washer and do not have a bracket.

Screw that goes through bracket is longer than the others.

(9)

Install two screws (20), three washers (21), spacer washer (21.11, four lockwashers (22), and

nuts (23).

(10)

Install screw (24), lockwasher (25), and ground wire (17).

(11)

Install washer (26) and nut (27) finger tight and take slack out of bracket (4).

(12)

Tighten nuts (27) and (29) against bracket (4).

c. Adjustment.

(1)

Hold lever (1) in run position.

(2)

Adjust nut (2) to touch bracket (3).

(3)

Tighten nuts (2 and 4) against

bracket (3).

(4)

Move lever (1) to stop position; if it

binds, loosen mounting bolts and realine

solenoid (5).

d.

Follow-on Maintenance.

(I)

Connect batteries (TM 9-2320-279-20).

(2)

Start engine and check operation of

engine stop switch (TM 9-2320-279-10).

(3)

Shut off engine (TM 9-2320-279-10).

(4)

Install engine cover (TM 9-2320-279-20).

(5)

Install engine side panel

(TM 9-2320-279-10).

END OF TASK

Change 2

15-41/(15-42 blank)