TM-9-2815-225-34-P
ENGINE, DIESEL: 6 CYLINDER IN-LINE TURBOCHARGED, CUMMINS MODEL NTC-400
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2005
TM-9-2815-225-34-P - Page 490 of 736
TM 9-2815-225-34&P
0052 00
0052 00-2
ILLUSTRATED LIST OF MANUFACTURED ITEMS (Contd)
PROCEDURE:
1. Using roller, measure 39.13 in. (99.39 cm) down dipstick from bottom of rubber stopper
and cut dipstick. Round off tip of dipstick.
NOTE
Use an electric engraver to perform etching in steps 2,
3, and 4. Etch dipstick to a depth of 0.005–0.010 in.
(0.127–0.254 mm).
2. Measure 36.31 in. (92.23 cm) down dipstick from bottom of rubber stopper and etch a
line on dipstick at this length. Etch an “H” next to this line.
3. Measure 2.06 in. (5.23 cm) down dipstick from line etched in step 3 and etch another
line at this length. Etch an “L” next to this line.
4. Etch part number 199453 on dipstick near rubber stopper.
ITEM 1. OIL LEVEL DIPSTICK
39.13 in.
(99.39 cm)
36.31 in.
(92.23 cm)
2.06 in.
(5.23 cm)
HL
Back to Top
