TM-9-6675-262-10
AIMING CIRCLE M2 W/E AND M2A2 W/E
TECHNICAL MANUAL; OPERATOR MANUAL
DECEMBER 2013
TM-9-6675-262-10 - Page 49 of 68
0009-1
0009
CHAPTER 4
MAINTENANCE INSTRUCTIONS
SERVICE UPON RECEIPT
INITIAL SETUP:
References
TM 9-6675-262-24&P
TM 9-6675-262-10, WP 0009
AR 735-11-2
DA Form 2404
DA Form 5988-E
DA Pam 25-30
DD 361
INTRODUCTION
The M2 or M2A2 Aiming Circle has no internal parts or assemblies replaceable by
Crew-Level personnel.
For maintenance and/or repair actions beyond those described
in this Operator Manual, see TM 9-6675-262-24&P
SERVICE UPON RECEIPT TASKS
1.
Inspect the equipment for damage incurred during shipment. If the equipment has
been damaged, report the damage on DD 361, Transportation Discrepancy
Report. Check the equipment against the packing slip to see if the shipment is
complete. Report all discrepancies in accordance with applicable service
instructions (e.g., for Army instructions, see AR 735-11-2).
2.
Check to see if the equipment has been modified. Determine whether there are
Modification Work Orders (MWOs) pertaining to the equipment, DA Pam 25-30,
Consolidated Index of Army Publications and Blank Forms.
3.
Upon receipt of the M2 or M2A2 Aiming Circle, fill out hard copies of DA Form
2404 or DA Form 5988-E, Equipment Inspection and Maintenance Record.
SERVICE UPON RECEIPT
No special sitting or shelter procedures are required for M2 or M2A2 Aiming Circle
maintenance tasks.
Back to Top
