TM-9-6920-430-14
COOLANT RECHARGING UNIT, TRAINING GUIDED MISSILE SYSTEM M80 AND CHARGER, BATTERY PP-7309/T
TECHNICAL MANUAL; OPERATOR’S AND ORGANIZATIONAL DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL
AUGUST 1980
TM-9-6920-430-14 - Page 39 of 180
TM 9-6920-430-14
2-3. TRAINER INSTALLATION
a. Lift the safety cover (9) at the rear of the GPU and open the two latches (10).
b. Facing the rear of the GPU, install the trainer onto the two cradles (11) with the
forward end to your left. Butt the performance indicator assembly against the inside of the
right cradle and fasten the latches (10).
Be sure that the trainer is physically secured in its cradles.
c. Close and latch the safety cover (9). Raise the IFF antenna (12), but do not allow it
to unfold until completion of step e.
Before removing fill cover from trainer in step d below, loosen small bleed
screw located on fill port cover 2 turns counterclockwise. This will permit
safe venting of any gas trapped in the launch tube.
Change 3
2-13
Back to Top
