PS Magazine - SEPTEMBER 1973
PS, The Preventative Maintenance Monthly
1973 SERIES, ISSUE 250
SEPTEMBER 1973
I:
I .
±
The external shields fR the com-
ponents aRe helD In place by thumb-
scRews .
.± whIch woRk loose duRIng
tRansIt±
WheneveR You Install the power
supPly, ReceIver oR Range computEr
IN theIR cases, be suRe to Flly tIghten
the
4
²steneRs on the panel o³
each Component.
OtheRwIse, the chassIs RIde loose
.´. anD you can bust up the plastIc
RunneRs on the sIdes .
.. or maYbe
even bounce a chassIs oµ the gRound±
¶³ _you Lose the scRews, Replace·
Ments aRe haRD to come by. BesIdes,
you might also lose a
EMi
shield.
All of which are pRetty good
reasons Fr tightEniNg the screws
beFre you leave
the gar-
rison ±±² and before you start
back.
¸xcellent pRotectIon ¹R the radar components when they'Re oº the
weap
O
n and out o³ theIR cases comes aS cheaply as slIppIng them In
the Reusable cases now In the supply sYsteM´
»oR UnIt
2
you need case, Reusable, »¼½
UnIts
3, 4,
and
5
need »¼½
1285³15´-4103µ
¶·
¾ou can get It so clean
damage the RotoR.
WhIch Is a sneaky way to cautIon
you agaInst soakIng the assembly In
lIquId cleanIng solvent´
A soLvent bath dIssolves the lube
on the assembly beaRIngs, and bear¿
Ings wIÀhout lube Damage the RotoR.
As the TÁÂs on the
ml63
and
ml67
say, you can use cÃeanIng solvent, but
use It caReÄÃLy´ And keep It away
Åom the beaRIngs.
WhIch brIngs up a PoInt: When
the beaRIngs have to be Replaced oRÆ
Repacked, tuRn the RotoR In Ào youR
Ǽ shop± ThatÂs woRk fR suPpoRt´
Back to Top Back to Top
