SB-86 Switchboard .
.±
G
ood PM keeps this oldie but goodie
tougH.
The Latch cord on the rear access
door of the TA-207 IP jack f±eLd section
gets tom or ²angLed when you shut the
door. Solve this proble² by tuck±ng in
the cord befOre you close the door³
Battery Power
F
or peak power, cHange aLL tHe bat´
ter±es when you put in Fesh ones.
When you store the sw±tchboard,
take out the ten BA-200 batteries and
the BAµ3030's, incLuding the two ±n
the key shelf sect±on and ±n the TA-207.
Easy on Gaskets
E
ye the gaskets in the sides of the
TA-207. ¶f a gasket is cracked or cH±p·
ped, get it repLaced.
¸o open the gaskets to ±nsert WD¹1
wire, use one ar² of a pair of pL±ers
or other bLuntµended tooL.
Th±s preº
vents gouged or cut gasKets.
Tighten Fasteners
T
ighten ca»Loc fasteners that HoLd
the rear door of the keysheLf and jack
¼±eLd section ±n place½
A ¾oose door Lets dust and dirt or
r
¿oisture ±nto the b±nd±ng posts. Dust
and d±R Ànd ¿o±sture w±¾L knockout
the teLephoneÁ
StoriNg Time
you shutdown your sw±tch´
board Âr packing ±t away, »aKe sure
rods that HoLd the PP-990
power suppLy are snug in the outer
cover asse²bLy.
Ãoose Lock rods let the power pack
bang against the switcHboard dur±ng
trans±t.
Th±s
bends
or
breaks the
sw±tchboardÄs pLugs.
Order by the Piece
Y
ou ²ust order each ±te² to ²aKe
NSN 51Å0-00-247-2063 ±s Âr the
up a kit.
TÃ-13 w±th sK±nners, wH±ch hÀve been
The ite»s are:
re-issued in suppLy.
TÃ-Å9 Æn±Ç
NSN 5ÈÈ0É00-240-5943
CSÊ34 Pouch
5È40-00Ë498-8898
TÃ-È3 P¾±ers
5ÈÅ0-00É239µ8Å54
w/o skinners
KnIfe TL²29
PlIERs TL²13
D³C ´´
4µ