LO-9-2350-247-12
CARRIER, CARGO TRACKED, 6-TON: M548A1 AND M548A3; CARRIER, ELECTRONIC WARFARE SYSTEMS, TRACKED, 6-TON: M1015A1
LUBRICATION ORDER
JULY 1994
LO-9-2350-247-12 - Page 40 of 43
KEY
EXPECTED
REFILL
TEMPERATURES*
FUEL CHART/COMPONENTS
CAPACITY
Above
+40°F
0°F
INTERVALS
(APPROX)
to
32°F
to
-10°F
-65°F
Diesel Fuel
2 qt.
DF-2
DF-1
DF-A
AF - After
VV-F-800
AN - Every 1,500 Miles
Fuel Filter
or annually
For Arctic Operation Refer to FM 9-207
NOTES
1. FUEL FILTERS. Daily, after operation, open drain
cocks and drain water, debris, etc. from each filter until
clear fuel is flowing into container. Dispose of waste
through Unit SOP.
2. On M1015A1 carriers, Iift up and secure center seat
support panel to access primary fuel filter drain cock.
WARNING
Dry cleaning solvent PD-680 is toxic and flam-
mable. Death or injury may result. Always use in
an open area with good airflow, away from sparks,
heat, or flames. Wear protective goggles and
gloves. Do not breathe vapors. Avoid contact with
skin, eyes, and clothes. If you get dizzy while using
solvent, breathe fresh air and get medical help. If
solvent gets on hands, wash them. If solvent gets
in eyes, flush eyes with fresh water and get medi-
cal help immediately. Keep fire extinguisher
nearby.
3. AIR BOX DRAIN/CRANCKCASE BREATHER
COLLECTION CAN (M548A1/M1015A1). Weekly, re-
move wing nuts. Lower can slowly to remove. Empty
can, dispose of contents per Unit SOP, and reinstall
(TM 9-2350-247-10). Every 25 hours, 250 miles, or
monthly, empty can and remove element. Clean ele-
ment and inside of can with dry cleaning solvent (PD-
680, type Ill) and reinstall.
4. OIL CAN POINTS. Every 1,500 miles, semi-
annually, or as required, lubricate tailgate hinges,
cargo door hinges, and driver’s throttle control linkage
pins and shafts, and seat control.
5. LUBRICATED AT TIME OF ASSEMBLY. Coat
ends of suspension torsion bar, idler wheel support
arm spindle and bearings, steering control linkage
bearing surfaces and pins, and towing pintle shaft with
GAA or GIA as specified during assembly. Late model
towing pintles do not have grease fittings and do not
require lubrication. Pack new support arm and idler
hub before assembly.
A copy of this lubrication order will remain with the
equipment at all times; instructions contained herein
are mandatory.
By Order of the Secretary of the Army:
GORDON R. SULLIVAN
General, United States Army
Chief of Staff
Official:
MILTON H. HAMILTON
Administrative Assistant to the
Secretary of the Army
07303
DISTRIBUTION: To be distributed in accordance
with DA Form 12-37-
E
, block 1403,
requirements for LO 235<0-247-12.
Card 40 of 40
U.S. GOVERNMENT PRINTING OFFICE:
1995
0-
398-894 (22013)
PIN: 011897-000
Back to Top
