LO-9-2350-247-12
CARRIER, CARGO TRACKED, 6-TON: M548A1 AND M548A3; CARRIER, ELECTRONIC WARFARE SYSTEMS, TRACKED, 6-TON: M1015A1
LUBRICATION ORDER
JULY 1994
LO-9-2350-247-12 - Page 31 of 43
LUBRICATION ORDER
LO
9-2350-247-12
8 JULY 1994
(Supersedes LO 9-2350-247-12, March 1982)
KEY
EXPECTED
REFILL
TEMPERATURES*
LUBRICANTS
CAPACITY
Above
+40°F
0°F
INTERVALS
(APPROX)
to
32°F
to
-10°F
-65°F
OE/HDO (MIL-L-2104C)
LUBRICATING OIL,
As Required
OE/
OE/
OEA
S - Every 75 Hours
OR OEA (MIL-L-46167)
INTERNAL COMBUSTION
HDO-10
HDO-10
on Engine Hour
ENGINE
Meter, semi-
Shelter, Puller Wire, Rope
annually
CW-11 (VV-L-751)
LUBRICATING OIL
As Required
C/MR - Upon
CHAIN-WIRE ROPE,
CW-11B
CW-11A
GOS
Contamination/
EXPOSED GEAR
During
Shelter, Puller Wire, Rope
Maintenance
GAA (MIL-G-10924)
GREASE, AUTOMOTIVE
As Required
Repair
AND ARTILLERY
All Temperatures
Generator Drive
For Arctic Operation Refer to FM 9-207
NOTES
WARNING
WARNING
Disengage the engine disconnect (TM 9-2350-247-
Use gloves when handling wire rope. Bare hands
10) before greasing generator drive universal joints.
can be cut by broken strands.
NOTE
1. GENERATOR DRIVE UNIVERSAL JOINT (2
If M1015A1 carrier has a shelter installed, it may be
places). Every 75 hours on engine hour meter (on
necessary (depending on the type of shelter) to
carrier instrument panel tachometer) or semi-annu-
slide shelter back on skid guides (see M1015A1
ally, remove drive shaft cover (TM 9-2350-247-20) and
portion of TM 9-2350-247-10) for access to some
lubricate. Each universal joint has two fittings, but only
lubrication points.
one requires lubrication. Reinstall drive shaft cover
(TM 9-2350-247-20).
2. SHELTER PULLER WIRE ROPE. Service only
when contaminated after use or during maintenance
repair. Pay out wire rope from ratchet drum. Clean wire
rope with oil (OE/HDO), wipe off excess oil, and coat
with oil (CW-11). Ratchet in wire rope.
Card 31 of 40
Back to Top
