LO-9-2350-247-12
CARRIER, CARGO TRACKED, 6-TON: M548A1 AND M548A3; CARRIER, ELECTRONIC WARFARE SYSTEMS, TRACKED, 6-TON: M1015A1
LUBRICATION ORDER
JULY 1994
LO-9-2350-247-12 - Page 23 of 43
LUBRICATION ORDER
LO
9-2350-247-12
8 JULY 1994
(Supersedes LO 9-2350-247-12, March 1982)
KEY
REFILL
EXPECTED TEMPERATURES*
LUBRICANTS
CAPACITY
INTERVALS
(APPROX)
Above
+40°F
0°F
+32°F
to -10°F
to -65°F
OHA (MIL-H-5606)
HYDRALIC FLUID,
1 pt.
PETROLEUM BASE
Pivot Steer
System
S - 150 Hours,
All Temperatures
1,500 Miles
GAA (MIL-G-10924)
GREASE, AUTOMOTIVE
As Required
or Semi-annually
AND ARTILLERY
Fan Drive Shaft
Steering Control Lever
For Arctic Operation Refer to FM 9-207
NOTES
1. FAN DRIVE SHAFT. Every 150 hours, 1,500 miles,
3. STEER CONTROL LEVER. Every 150 hours,
or semi-annually, lubricate fan drive shaft bearings
1,500 miles, or semi-annually, lubricate steering con-
with grease, GAA, through fittings at each end of shaft.
trol lever shaft bearings with grease, GAA.
Use grease gun with flexible adapter. Fittings are
located behind front and rear fan drive shaft pulleys.
CAUTION
Use only OHA petroleum base hydraulic fluid.
DO NOT use brake fluid. DO NOT overfill.
Do not attempt to grease pivot steer bleeder
valves.
2. PIVOT STEER SYSTEM. Every 150 hours, 1,500
miles, or semi-annually, remove plugs and check fluid
level in both master cylinders (TM 9-2350-247-20).
Add fluid (OHA) as required to bring fluid within 1/2 to
3/4 inch from top of cylinder.
Card 23 of 40
Back to Top
