MWO-5-2350-262-35-2
ARMORED COMBAT EARTHMOVER (ACE), M9
MODIFICATION WORK ORDER
MWO-5-2350-262-35-2 - Page 31 of 33
MWO 5-2350-262-35-2
3
-
2
WARNING
CARC paint is extremely toxic.
It can irritate skin and cause burns.
Avoid inhaling.
Use
only with adequate ventilation.
Avoid contact with skin, eyes, or clothing.
In case of
contact, immediately flush skin or eyes with water for at least 15 minutes.
Get medical
attention for eyes.
Failure to comply may result in injury to personnel.
Serious hearing loss and eye injury can occur during drilling and grinding operations.
Wear ear and eye protection.
Failure to comply may result in injury to personnel.
NOTE
Steps 6 through 9 below apply to Figure 3-1.
6.
Use suitable cutting device to cut left seatbelt bracket (2) at a distance 0.5 inches (12.7 mm) from center of
existing left seatbelt bolt hole.
2
1
0.5 in.
Left Seatbelt New
Location
Figure 3-1.
Left Seatbelt Bracket.
WARNING
CARC paint is extremely toxic.
It can irritate skin and cause burns.
Avoid inhaling.
Use
only with adequate ventilation.
Avoid contact with skin, eyes, or clothing.
In case of
contact, immediately flush skin or eyes with water for at least 15 minutes.
Get medical
attention for eyes.
Failure to comply may result in injury to personnel.
Serious hearing loss and eye injury can occur during drilling and grinding operations.
Wear ear and eye protection.
Failure to comply may result in injury to personnel.
7.
Use suitable grinding device and smooth edge (1) cut in step 6 above.
8.
Measure distance from compartment floor to center of existing left seatbelt bolt hole.
Mark new hole 2.5
inches (63.5 mm) towards vehicle front from existing hole and height measurement previously recorded.
9.
Using ½ inch diameter drill bit, drill a 1/2 inch (12.7 mm) through hole in left seatbelt bracket (2).
NOTE
Step
10 below applies to Figure 3-2.
10. Using 7/32 inch diameter drill bit, drill eight 7/32 inch (5.556 mm) holes and tap ¼ inch x 20 in driver’s
compartment back wall and next to left side wall.
Back to Top
