MWO 5-2350-262-35-2
2
-
22
NOTE
Steps 2 through 5 below apply to Figure 2-29.
2.
Fill one bottle (7) with solution from Section IV, step a.
9
4
11
1
10
5
6
7
2
3
8
Figure 2-29.
Charge/Purge Kit for MCU.
3.
Connect black tube (2) on release tether (1) to black connector (4) on lid (6) of FILLED bottle (7).
4.
Connect clear tube (11) on release tether (1) to white connector (10) on lid (9) of EMPTY bottle (8).
5.
Connect pump (3) to white connector (5) on lid (6) of FILLED bottle (7).
NOTE
Steps 6 through 9 below apply to Figure 2-30.
Solution will begin to flow into EMPTY bottle to indicate that MCU is flooded.
6.
Operate hand pump (5) to fill MCU (1).
1
2
3
4
7
6
5
Figure 2-30.
Charging MCU.
7.
Disconnect MCU (1) from release tether (2).