MWO-5-2350-262-35-2
ARMORED COMBAT EARTHMOVER (ACE), M9
MODIFICATION WORK ORDER
MWO-5-2350-262-35-2 - Page 17 of 33
MWO 5-2350-262-35-2
2
-
12
NOTE
Step 3 below applies to Figure 2-13.
3.
Continue routing the MCU Power Lead (12491611-2) (2) forward, behind the instrument panels and out the
lower front hole (1) of the driver’s compartment.
Figure 2-13.
MCU Power
Lead Routing from Circuit
Breaker to Lower Front of Driver’s Compartment.
1
2
NOTE
Step 4 below applies to Figure 2-14.
4.
Route the MCU Power Lead (12491611-2) (2) along the existing wire harness (3).
Use 5 or 6 Electrical Tie
Straps (MS 3367-2-0) (4) to connect the MCU Power Lead (12491611-2) (2) to the existing Wiring Harness
(3) on the front and right outside of the driver’s compartment.
Connect the MCU Power Lead (12491611-2)
(2) end to the end of the MCU Power Lead (12491611-1) (1) on the right outside of the driver’s compartment
inside the engine compartment.
2
3
1
4
Figure 2-14.
MCU Power Lead Routing from Driver’s Compartment to Engine Terminal.
Back to Top
