MWO-5-2350-262-35-2
ARMORED COMBAT EARTHMOVER (ACE), M9
MODIFICATION WORK ORDER
MWO-5-2350-262-35-2 - Page 10 of 33
MWO 5-2350-262-35-2
2-5
NOTE
Step 5 below applies to Figure 2-3.
5.
Using a 1/2 inch diameter drill bit and a drill stop gauge set, drill a 1/2 inch (12.7 mm) hole, 1/2 inch (12.7
mm) deep into the fuel tank armor plate (1) at location (2) drilled in step b.3. above.
Tap hole (2) using a
bottom end tap set to 9/16-12 UNC-2-A.
Install steel insert (MS51831-204) into threaded hole (2).
1
2
NEW HOLE
DRILLED IN
STEP b.3.
ABOVE
Figure 2-3.
Drilling, Tapping and Installing Steel Insert in Fourth Mounting Hole.
Back to Top
