MWO-5-2350-262-35-2
ARMORED COMBAT EARTHMOVER (ACE), M9
MODIFICATION WORK ORDER
MWO-5-2350-262-35-2 - Page 5 of 33
MWO 5-2350-262-35-2
1-3/(1-4 blank)
1-13
QUALITY ASSURANCE REQUIREMENTS.
a. General.
Quality assurance will be accomplished in accordance with TM 750-245-4.
b. Physical Inspection.
Check components that are removed or installed during the modification for stability of
mounting.
c.
Functional Inspection.
Start vehicle and insure that vehicle is operating properly, in accordance with TM 5-
2350-262-10.
1-14
RECORDING AND REPORTING OF THE MODIFICATION.
a. Reporting Requirement.
The organization responsible for MWO application will report application information
as follows:
(1)
Reporting will be accomplished by electronic means. MWO application information can be input directly
in the Modification Management Information System (MMIS) over the Internet.
Entry into the MMIS system is
password protected.
New users can register on-line at
.
Passwords are normally
approved and issued within 48 hours.
(2)
Submission will be comprised of the nine (9) data elements listed in the Table below.
Elements 1, 2, & 8
are given for this MWO (as shown).
The person reporting the MWO data will acquire the remaining elements
3, 4, 5, 6, 7 & 9 and input all nine into MMIS.
DATA ELEMENT
INPUT DATA
1.
Materiel Change Number (MCN)
1-04-05-0009
2.
MWO Number
MWO 5-2350-262-35-2
3.
Unit Identifier Code
4.
NSN of the End Item
5.
Serial Number
6.
USA Registration Number
7.
Date of Application
8.
Hours Required for Application
6 or 16
9.
Applied by:
(Name)
(3)
If you do not have access to the Internet, recording will be on a 3.5 inch disk (or CD), which will be mailed
to the MMIS administrator to the following address:
Commander
U.S. Army Tank-automotive and Armaments Command
6501 E. 11 Mile Road
ATTN:
AMSTA-LC-LMIM/MS 419
Warren, MI 48397-5000
b. Records and Reports.
Record the modification in accordance with AR 750-10, DA Pam 738-750, and DA
Pam 738-751.
c. Marking Equipment.
Stamp “MWO 35-2” on existing vehicle data plate 13214E2452.
1-15
MATERIEL CHANGE (MC) NUMBER.
This Modification Work Order is authorized by MC number 1-04-05-0009.
1-16 MODIFICATION IDENTIFICATION.
See applicable chapters.
Back to Top
